Documentation

How to Use Your USG

The USG firewall is easy to use - just insert it between your computer and the device you wish to isolate.

Supported Devices

The USG supports the following devices at USB 1 speeds (12Mbps).

Mass storage	Flash drives and hard drives, 512byte sectors and 2TB max
Mice	4 buttons with scroll wheel
Keyboards	101 keys

Additional Security Features

Besides protecting you with an internal firewall, Armadillo also provides additional security features:

Separate Read/Write Indication Inspired by Bruce Schneier, the Armadillo shows you what your computer is doing. Yellow blinks when reading your mass storage device, and red blinks when writing.

Bot Detection prevents keyboards and mice from entering malicious commands when you are not at your computer. If bot detection is activated your input will temporarily lock and the red (upstream) LED will double-flash every second. Repeated bot detection will cause a permanent lock. To reset the lock, simply unplug and re-insert Armadillo.

LED Error Codes

LED flashing like this:	...means this:
Yellow or red rapid-blinks	Mass storage reading (yellow) or writing (red)
Yellow or red 5 flashes per second	Internal firmware error, communication shut down
Yellow (downstream) 1 flash per second	The connected USB device is not supported
Red (upstream) Double flash per second	HID bot detect activated, unplug to reset

Tamper Protection

The USG’s case is sealed with tamper-evident glitter epoxy to protect against physical tampering or replacement. Photographing both sides of the case allows you to later verify that your firewall has not been tampered with.

Still Have Questions?

Check out the FAQ!